Subject: Re: Install problems
From: Jay Estabrook (Jay.Estabrook@compaq.com)
Date: Thu Oct 19 2000 - 07:57:32 PDT
On Thu, Oct 19, 2000 at 01:24:50AM -0700, Jakob 'sparky' Kaivo wrote:
>
> I seem to be having the exact opposite problem. I have a PC-164 with a
> SCSI disk (Seagate Barracuda) and Tekram controller (DC-390F), but
> while installation goes fine, SRM is *not* happy. When I run "show
> config", the controller is shown, but "show device" shows only the
> floppy drive (DVA0). Does anyone have any experience with SRM not
> liking Tekram controllers?
SRM is not guaranteed to like *any* card that it wasn't tested/sold
with. That's not to say it won't work with an arbitrary card, but
that card best "look like" (PCI vendor/device IDs) one that it was
tested against.
If you don't have the latest SRM console version, try updating to it
and then try again. If it still fails, I guess you're out of luck...
Good luck.
--Jay++
-----------------------------------------------------------------------------
Jay A Estabrook Alpha Engineering - LINUX Project
Compaq Computer Corp. - MRO1-2/K20 (508) 467-2080
200 Forest Street, Marlboro MA 01752 Jay.Estabrook@compaq.com
-----------------------------------------------------------------------------
-- To UNSUBSCRIBE, email to debian-alpha-request@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
This archive was generated by hypermail 2a22 : Thu Nov 02 2000 - 08:06:30 PST