Should see a 1040. What version of SRM did you snag?
What is the output of
show config
sho dev
I have two PC164s that are quite happy with several flavors of pci1077,1020.
> I just replaced ARC with SRM on
> several PC164s and now I see that
> only the floppy is seen on all of the systems.
>
> A few see (show dev) a primary ide
> device, but it depends on what kind
> of disk is attached.
>
> None of my Intel Etherexpress Pro 100 Bs
> are seen. I thought this one was included
> on the latest SRMs. What is the deal here?
> No ethernet has been attached yet.
> Will I see it light up when theres a pulse?
>
> My Qlogic ISP1040B (reported to be
> a 1020 under /proc/scsi/scsi) is not
> seen. When I was looking around for
> a SCSI controller for this purpose,
> the consensus was that the ISP1020
> and 1040 would work. What could
> be wrong here. (It works fine
> after I've booted off of the floppy
> using the install kernel.)
>
> Bob Williams
>
>
>
>
> _______________________________________________
> Axp-list mailing list
> Axp-list@redhat.com
> https://listman.redhat.com/mailman/listinfo/axp-list
>
_______________________________________________
Axp-list mailing list
Axp-list@redhat.com
https://listman.redhat.com/mailman/listinfo/axp-list
This archive was generated by hypermail version 2a22 on Fri Dec 1 08:00:06 2000 PST
Send any problems or questions about this archive to webmaster@alphalinux.org.