Axp-List Archive
Re: Hard Drive size on Jensen

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Next message: Luiz Emediato: "Re: JumpStart! v 1.4.1 is failing on my Jensen"
• Previous message: Graeme Hogg: "RE: Hard Drive size on Jensen"
• In reply to: Luiz Emediato: "RE: Hard Drive size on Jensen"
• Reply: Alexey Chupakhin: "Re: Hard Drive size on Jensen"

Hi Luiz!
Excuse me very much for waiting.
This is my df report.
To partition it,
I run minlabel in ARC mode and make 2MB ext2 partition, copyboot from
Jensen's "boot" diskete and start Linux ander SRM console using aboot 0.7.
During installation procedure I was invited to partition disk by druid.
I make swap and ext2 root partitions.

Filesystem Size Used Avail Use% Mounted on
/dev/sdc2 6.7G 1.1G 5.2G 17% /
/dev/sda1 1010M 960M 50M 96% /WindowsNT

(I allocated about 2GB for FAT16 - you can't see it).

regards,
Alexey

_______________________________________________
Axp-list mailing list
Axp-list@redhat.com
https://listman.redhat.com/mailman/listinfo/axp-list

• Next message: Luiz Emediato: "Re: JumpStart! v 1.4.1 is failing on my Jensen"
• Previous message: Graeme Hogg: "RE: Hard Drive size on Jensen"
• In reply to: Luiz Emediato: "RE: Hard Drive size on Jensen"
• Reply: Alexey Chupakhin: "Re: Hard Drive size on Jensen"

This archive was generated by hypermail version 2a22 on Fri Jun 1 04:36:14 2001 PDT
Send any problems or questions about this archive to webmaster@alphalinux.org.