That means you/the installer didn't setup BSD disklabels.
--rdp
On Mon, 5 Mar 2001, kingmiro wrote:
> Hello,
>
> I get an " Bootstrap Failure after Installation of Red Hat Linux 7.0 " !!!
>
> Everything works propperly, after I´ve installed Red Hat linux 7.0 the machine
> reboots ...
>
> After the start in the SRM-Console, the machine boots automaticaly ...
> But I get the error-code :
> block 0 of dkc1100 is not a valid boot block
> bootstrap failure
>
> --> dkc1100 is my HDD-Drive !
>
> I´ve tried a lot of things nothing helps ..
>
> thankz
>
> http://www.kingmiro.de
>
-- Rich Payne rpayne@alphalinux.org www.alphalinux.org_______________________________________________ Axp-list mailing list Axp-list@redhat.com https://listman.redhat.com/mailman/listinfo/axp-list
This archive was generated by hypermail version 2a22 on Tue Apr 10 10:35:31 2001 PDT
Send any problems or questions about this archive to webmaster@alphalinux.org.