Axp-List Archive
Bootstrap Failure after Installation of Red Hat Linux 7.0

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Next message: warren.daly@broadcom.ie: "RE: Rh-7.0 upgrade. X gone haywire"
• Previous message: warren.daly@broadcom.ie: "RE: Milo on RH 7"
• Next in thread: Rich Payne: "Re: Bootstrap Failure after Installation of Red Hat Linux 7.0"

Hello,

I get an " Bootstrap Failure after Installation of Red Hat Linux 7.0 " !!!

Everything works propperly, after I´ve installed Red Hat linux 7.0 the machine
reboots ...

After the start in the SRM-Console, the machine boots automaticaly ...
But I get the error-code :
block 0 of dkc1100 is not a valid boot block
bootstrap failure

--> dkc1100 is my HDD-Drive !

I´ve tried a lot of things nothing helps ..

thankz

http://www.kingmiro.de

• Next message: warren.daly@broadcom.ie: "RE: Rh-7.0 upgrade. X gone haywire"
• Previous message: warren.daly@broadcom.ie: "RE: Milo on RH 7"
• Next in thread: Rich Payne: "Re: Bootstrap Failure after Installation of Red Hat Linux 7.0"

This archive was generated by hypermail version 2a22 on Tue Apr 10 10:35:31 2001 PDT
Send any problems or questions about this archive to webmaster@alphalinux.org.