Axp-List Archive
Re: Multia dead after attempted switch to SRM

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Next message: Luke Brennan: "Re: Booting linux Red Hat install from MILO on XL233 ?"
• Previous message: Michal Jaegermann: "Re: Booting linux Red Hat install from MILO on XL233 ?"
• Maybe in reply to: Champigny, Michael: "Multia dead after attempted switch to SRM"
• Next in thread: Jay Estabrook: "Re: Multia dead after attempted switch to SRM"
• Maybe reply: jmd: "Re: Multia dead after attempted switch to SRM"

>I'm guessing it might be the fixed frequency VGA modes. Maybe I
>have to set a different video mode with the jumpers. However, I have
>a good multi-sync attached so I don't see why this should be a problem.

I did the same thing with a Multia. I switched to SRM and it was a blank
screen. I had a cheap 14" monitor attached. I plugged in a ViewSonic G790
and there it was.... an SRM prompt.

Your machine will probably accept commands, and you can blindly type in
*arc* (be wise to check this out first) and ARC will restart if I remember
right. Again... check this out before actually doing it.

jeff

-- 
To unsubscribe: send e-mail to axp-list-request@redhat.com with
'unsubscribe' as the subject.  Do not send it to axp-list@redhat.com

• Next message: Luke Brennan: "Re: Booting linux Red Hat install from MILO on XL233 ?"
• Previous message: Michal Jaegermann: "Re: Booting linux Red Hat install from MILO on XL233 ?"
• Maybe in reply to: Champigny, Michael: "Multia dead after attempted switch to SRM"
• Next in thread: Jay Estabrook: "Re: Multia dead after attempted switch to SRM"
• Maybe reply: jmd: "Re: Multia dead after attempted switch to SRM"

This archive was generated by hypermail version 2a22 on Tue Aug 1 04:53:11 2000 PDT
Send any problems or questions about this archive to webmaster@alphalinux.org.