Good morning linux fans,
I have just installed rh 6.1 on an hp netserver. The 3c905b and smc
ethernet cards were not detected upon install. Since I cannot get the
xserver up how can I add the software modules for these cards? I tried
using linuxconf but I did not know the module names (is there a list of
them somewhere?) and even after that I could not ping the ip address of
ther device itself nor the default gateway which I added. Network
unreachable. Any hints, tips tricks would be great. Thanks!
Wade B
-- To unsubscribe: send e-mail to axp-list-request@redhat.com with 'unsubscribe' as the subject. Do not send it to axp-list@redhat.com
This archive was generated by hypermail version 2a22 on Wed Mar 1 06:26:23 2000 PST
Send any problems or questions about this archive to webmaster@alphalinux.org.