On Thu, Dec 02, 1999 at 10:04:50PM +0100, m.groeneveld@speed.a2000.nl wrote:
> Hello,
>
> I have a noname alpha axppci33 board with 166MHz cpu and
> onboard ncr 810 scsi interface. Also i have some old quantum els
> 127 harddisks. With RedHat 6.0 (2.2.5 kernel) which works fine on
> my ide drive i get scsi abort when i attach a scsi drive. Then it
> hangs. Can i tweak something so it will run, or are there problems
> with the scsi driver? Is the driver only for new harddisks? Should i
> use an older kernel? Or is it a hardware problem?
Correct termination (page 25 in your AXPpci-handbook)? Bad cable? Cable
connected the right way round (there are some cables without key on the plugs)?
I have the same board and used 2.2.7, 2.2.14pre6, 2.3.10 and now 2.3.30pre3.
Never had any scsi problems (7 devices connected).
Bye,
Thorsten
-- | Thorsten Kranzkowski Snail: Niemannsweg 30, 49201 Dissen, Germany | | Mobile: ++49 161 7210230 Inet: dl8bcu@gmx.net | | Ampr: dl8bcu@db0nei.#nrw.deu.eu, dl8bcu@marvin.dl8bcu.ampr.org [44.130.8.19] |-- To unsubscribe: send e-mail to axp-list-request@redhat.com with 'unsubscribe' as the subject. Do not send it to axp-list@redhat.com
This archive was generated by hypermail version 2a22 on Mon Jan 3 11:15:09 2000 PST
Send any problems or questions about this archive to webmaster@alphalinux.org.