For the PWS series miata.gz not miata-s.gz is the correct image from the 5.2
install (for use with milo). There is
only one generic kernel image for the 6.0 install, so you would have to use
that one.
James
------------------------------------------------------------------------------
James Fowler
Graduate Student Political Science & Latin America
Arizona State University
jamesvi@asu.edu ICQ: 22088266
-----------------------------------------------------------------------------
On Wed, 1 Dec 1999, Gary Grobe wrote:
> I've put linload.exe and milo on a floppy and then configured the setup on
> the Windows NT ARC firmware. So when the machine boots off the floppy, I do
> get a MILO prompt. I think I'm supposed to put a kernel image on another
> floppy now and use the boot command but I'm having
> trouble finding the correct image for the miata. The machine is a personal
> workstations 500a (miata).
>
> Can someone verify that this is the correct procedure I'm doing, and if so,
> point me to a good image so that I can do a network install?
>
> ---
> Gary
>
> --
> To unsubscribe: send e-mail to axp-list-request@redhat.com with
> 'unsubscribe' as the subject. Do not send it to axp-list@redhat.com
>
>
-- To unsubscribe: send e-mail to axp-list-request@redhat.com with 'unsubscribe' as the subject. Do not send it to axp-list@redhat.com
This archive was generated by hypermail version 2a22 on Mon Jan 3 11:15:08 2000 PST
Send any problems or questions about this archive to webmaster@alphalinux.org.