Hi,
I finally installed RedHat6 on my 150 AXP. Very thanks to everybody,
sincerely.
I now have another problem: It doesnt boot!!!!.
I write:
aboot> 0
And then starts loading the kernel 2.2.5 that RH6 installs. But when it
tries to start "kswapd" (almost in the begining) it hangs (and says
nothing).
Tomorrow I'm going to remove the swap partition to see if it helps.
Any more sugestions?
NOTE: If I start the kernel used during the installation it goes further:
aboot> 0/a
It actually starts all the kernel and begin starting all the
services, network, ..., with errors saying "no modules.dep in
lib/modules/2.2.12/", "Incorrect System.map", ...
It hangs just after initializing the network (eth0).
--Saludos
-------------------------------------------------- Fernando Monera Daroqui
email: Fernando.Monera@iit.upco.es -------------------------------------------------- Tlf: (91) 542 28 00 Instituto de Investigación Tecnológica Escuela Técnica Superior de Ingeniería (ICAI) Universidad Pontificia Comillas
C/ Sta Cruz de Marcenado no. 26 28015 MADRID - SPAIN -------------------------------------------------- No se ha usado ningún producto comercial para escribir éste mensaje. linux reg Nº: 94004 (http://counter.li.org) --------------------------------------------------
-- To unsubscribe: send e-mail to axp-list-request@redhat.com with 'unsubscribe' as the subject. Do not send it to axp-list@redhat.com
This archive was generated by hypermail version 2a22 on Mon Jan 3 11:15:08 2000 PST
Send any problems or questions about this archive to webmaster@alphalinux.org.