Christoph Franzen (Christoph_Franzen@outpost.fido.de)
Sat, 17 Apr 1999 20:02:41 +0200
GI> I've got an ATI mach64 ISA card and I try to use it with my Jensen. The
GI> problem is that, when I insert the card the monitor's sreen is fall
GI> appart and "run". [...] As I know Tru64 supports this card, so why it's
GI> not working at the console prompt? I tried to run ECU and added the board
GI> at eisa slot 0, but it's still not working. I'm using firmware v1.7.
The firmware version is fine. Did you add it as standard VGA?
As far as I know, only SVGA and S3 are supported on the Jensen.
Viele Grüße, Christoph
-- To unsubscribe: send e-mail to email@example.com with 'unsubscribe' as the subject. Do not send it to firstname.lastname@example.org
This archive was generated by hypermail 2.0b3 on Sun Apr 18 1999 - 20:00:30 PDT