Re: "Cannot run /bin/insmod" in UDB installation

jestabro@amt.tay1.dec.com
Sun, 24 Nov 1996 21:29:53 +0500

>>> Mike Epstein said:
> Just got my UDB, and after selecting NCR 53C810/53C820 PCI for my SCSI
> adapter, it tells me "cannot run /bin/insmod". I'm following the
> instructions exactly. Any suggestions?

If the kernel didn't find the NCR810 during bootup, check into whether it is
found by the ARC console; select the "Display Hardware Configuration" from
the appropriate menu, and see if it shows the controller and disk(s). If
not, then the little riser card inside, which has the NCR810 on it may be
loose. Open up the box and mke sure it's seated properly.

--Jay++

-------------------------------------------------------------------------------
American Non Sequitur Society: we don't make sense, but we do like pizza...

Jay A Estabrook Alpha Migration Tools - LINUX Project
Digital Equipment Corp. (508) 952-4202 or (DTN) 227-4202
151 Taylor Street - TAY1-2 enet: jestabro@amt.tay1.dec.com
Littleton, MA 01460-1407 decnet: tallis::jestabro
-------------------------------------------------------------------------------

--
To unsubscribe: send e-mail to axp-list-request@redhat.com with
'unsubscribe' as the subject.  Do not send it to axp-list@redhat.com



Feedback | Store | News | Support | Product Errata | About Us | Linux Info | Search | JumpWords
No Frames | Show Frames

Copyright © 1995-1997 Red Hat Software. Legal notices