installing MILO on UDB, RedHat 2.018
Robin Stephenson (firstname.lastname@example.org)
12 Nov 1996 09:38:50 +0000
After much travail I have RH installed on my new UDB. Unfortunately
it won't boot without the aid of a floppy disk containing MILO. Once
milo is loaded from the floppy it will boot from the hard disk with
boot sda1:vmlinux.gz root=/dev/sda1
and will perform software (non-power-off) reboots until the cows come
I guess that I need to get MILO into the boot blocks of the drive:
how do I do this? If it's already on there, what do I need to enter
for these values in the ARC console?
PS I gather that I'll need a special bracket to mount a 3 1/2" drive
inside the UDB. Does anyone know where I could get hold of one of
these (preferably in the UK): 2 1/2" drives are rather small/pricey.
Does the 3 1/2" option run any risk of causing overheating problems?
Robin Stephenson - send mail with subject `send pgp key' for my key
Recipe Tested In A 650-Watt Microwave Oven
To unsubscribe: send e-mail to email@example.com with
'unsubscribe' as the subject. Do not send it to firstname.lastname@example.org
Product Errata |
About Us |
Linux Info |
No Frames |
Copyright © 1995-1997 Red Hat Software. Legal notices