If any card you put in there causes this, then I'd say you've got a bad
slot. Historically I can't think of any problems with the last slot in
LXs.
--rdp
On Tue, 23 Jan 2001, Markus Klappenbach wrote:
> Hi all,
>
> i have a problem with my 164LX board. i try to install a pci card in the
> last pci slot (DEC NIC 21140 which works fine in any other slot). the
> configuration is as follows: slot0; Matrox Millenium, slot1; HBA Symbios
> 8751SP, slot2; WintTV PCI and slot3;?. if i install any card in any
> combination in the last slot the system does not boot with SRM-5.8-1 (no
> VGA Signal) and with AlphaBios-5.70 the system boots but WINNT4 crashes
> with NMI: Parity error. if i remove the card from slot3 the SRM Console
> boots and i am able to boot Redhat-7.0
> the board is powered with an enermax 335W power-supply.
>
> thanks for all suggestions
>
> Greetings from Germany
> Markus
-- Rich Payne rpayne@alphalinux.org www.alphalinux.org_______________________________________________ Axp-hardware mailing list Axp-hardware@lists.alphalinux.org http://lists.alphalinux.org/mailman/listinfo/axp-hardware
This archive was generated by hypermail version 2a22 on Sat Mar 3 12:54:52 2001 PST
Send any problems or questions about this archive to webmaster@alphalinux.org.