Axp-Hardware Archive
[Axp-hardware] PCI Slot Problem

• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Next message: Rich Payne: "Re: [Axp-hardware] PCI Slot Problem"
• Previous message: Ron Farrer: "[Axp-hardware] Re: broken tape in TZ87?"
• Next in thread: Rich Payne: "Re: [Axp-hardware] PCI Slot Problem"

Hi all,

i have a problem with my 164LX board. i try to install a pci card in the
last pci slot (DEC NIC 21140 which works fine in any other slot). the
configuration is as follows: slot0; Matrox Millenium, slot1; HBA Symbios
8751SP, slot2; WintTV PCI and slot3;?. if i install any card in any
combination in the last slot the system does not boot with SRM-5.8-1 (no
VGA Signal) and with AlphaBios-5.70 the system boots but WINNT4 crashes
with NMI: Parity error. if i remove the card from slot3 the SRM Console
boots and i am able to boot Redhat-7.0
the board is powered with an enermax 335W power-supply.

thanks for all suggestions

Greetings from Germany
Markus

• Next message: Rich Payne: "Re: [Axp-hardware] PCI Slot Problem"
• Previous message: Ron Farrer: "[Axp-hardware] Re: broken tape in TZ87?"
• Next in thread: Rich Payne: "Re: [Axp-hardware] PCI Slot Problem"

This archive was generated by hypermail version 2a22 on Sat Mar 3 12:54:52 2001 PST
Send any problems or questions about this archive to webmaster@alphalinux.org.